rig out

英 [ˈrɪɡ aʊt]

美 [ˈrɪɡ aʊt]

网络  打扮; 装配; 装扮

英英释义

verb

• put on special clothes to appear particularly appealing and attractive
  1. She never dresses up, even when she goes to the opera
  2. The young girls were all fancied up for the party
  Synonym:overdressdress upfig outfig updeck upgussy upfancy uptrick updeck outtrick outprinkattireget uptog uptog out

双语例句

• It also gives out the concrete form of the compounded control system design, introduces the present actual state of the electric drive drill rig, and points out its developing directions.
  给出了复合型控制系统设计的具体形式，介绍了当前电驱动钻机的现状，指出了其发展方向。
• Hence, 120 h simulating road test on a test rig is carried out.
  为此，在试验台上进行了120h模拟道路行驶试验。
• I rigged myself out in thick jeans and heavy belt
  我穿上厚厚的牛仔裤，系上重重的皮带。
• The drilling expedition, including a rig and support ships, was choreographed for the summer months, when the Kara Sea is free of ice, ruling out any delays.
  这只钻探队伍包括了一座钻台和一些支援船只，计划在夏季的几个月里执行任务，这段时间喀拉海上没有冰，从而避免了可能的延误。
• To use rig arm carry out single wire-line right and left percussion handle drilling tool jamming in soft sandy strata;
  利用钻机大、小臂进行单绳左右冲击处理软砂地层夹钻事故；
• A test rig is set up and the experiment on the valve is carried out at the room temperature and high temperature. The experimental proportional characteristics are obtained and compared with the simulation results.
  搭建了试验台，分别在常温与高温条件下进行阀的特性试验研究，给出了比例阀的比例特性曲线，并与仿真结果进行了比较。
• The paper analyses functions and characteristics of all kinds of workover rig, proposes out existing problems during well workover.
  文中分析了各类型号修井机的功能和特点，提出了在修井过程中存在的问题；
• On the basis of cold qualification test, the irradiation tests ( closed capsule and sweep loop rig) of the coated fuel particles for 10 MW high temperature gas-cooled reactor ( HTR-10) were carried out.
  在冷态性能检验合格的基础上，进行了10MW高温气冷堆包覆燃料颗粒的静态辐照试验和动态回路辐照试验。
• Author point that the development emphasis of Chinese domestic on mobile rig design still on the imitation and parts selection, few investigation was carried out on the design theory and match principal.
  论文指出国内的研发重点还是在模仿与部件的选型上，对于部件本身的设计原则、配套理论很少进行研究。
• Finite element analysis of a mast type derrick of 80 t offshore workover rig is carried out.
  对80t海洋修井机井架进行了有限元计算。